Vector VEC1087 A Manuel du propriétaire

Naviguer en ligne ou télécharger Manuel du propriétaire pour Chargeurs de batterie Vector VEC1087 A. Vector VEC1087 A Owner`s manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 10
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
SMART AUTOMATIC
BATTERY CHARGER
12 VOLT 2/6/10 AMP CHARGE RATES
OWNER’S MANUAL & WARRANTY INFORMATION
• IMPORTANT SAFETY INSTRUCTIONS •
WARNING – RISK OF EXPLOSIVE GASES
1. WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES
GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS
REASON, IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR
CHARGER, YOU READ THIS MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY.
2. To reduce risk of battery explosion, follow these instructions and those published by the battery
manufacturer and manufacturer of any equipment you intend to use in vicinity of battery. Review
cautionary markings on these products and on engine.
GENERAL BATTERY SAFETY
1. Use this charger for charging a 12 VOLT LEAD-ACID battery only. It is not intended to supply power to a low voltage
electrical system other than in automotive applications. Do not use this battery charger for other types of batteries,
these may burst and cause injury to persons and damage to property.
2. Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire,
electric shock, or injury to persons.
3. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.
4. An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result
in a risk of fire and electric shock.
If extension cord must be used, make sure:
a. That pins on plug of extension cord are the same number, size, and shape as those of plug on charger.
b. That extension cord is properly wired and in good electrical condition; and
c. That wire size is AWG #14 (14 gauge) to 100 feet and AWG #12 for distances over 100 feet.
5. Do not operate charger with damaged cord or plug - replace immediately.
6. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take
it to a qualified service technician.
7. Do not disassemble charger; take it to a qualified service technician when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or fire.
8. To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Turning
off controls will not reduce this risk.
9. Do not expose charger to rain, snow or use when wet.
10. Never charge a frozen battery.
SAVE THESE INSTRUCTIONS:
This manual contains important safety and operating instructions for battery charger Model VEC1087 AA
4140 SW 28TH WAY, FT. LAUDERDALE, FL 33312 • TEL: 954-584-4446 • FAX: 954-584-5556 • TOLL-FREE 866-584-5504
VEC1087 A
This device complies with Part 15 of the FCC Rules.
Vue de la page 0
1 2 3 4 5 6 7 8 9 10

Résumé du contenu

Page 1 - SAVE THESE INSTRUCTIONS:

SMART AUTOMATICBATTERY CHARGER12 VOLT 2/6/10 AMP CHARGE RATES OWNER’S MANUAL & WARRANTY INFORMATION• IMPORTANT SAFETY INSTRUCTIONS •WARNING – RISK

Page 2 - FIGURE 1A FIGURE 1B

VEC1087 AREV10110310VECTOR 5 YEAR LIMITED WARRANTY PROGRAMThis limited warranty program is the only one that applies to this product, and it sets fort

Page 3 - DC CONNECTION PRECAUTIONS

VEC1087 AREV1011032PERSONAL PRECAUTIONS AND SAFETY1. Another person should be close enough to come to your aid when you work near a lead-acid battery.

Page 4 - FEATURES

VEC1087 AREV1011033PREPARING TO CHARGE1. Determine voltage of battery by referring to car owner's manual.2. If it is necessary to remove battery

Page 5 - CONTROLS AND INDICATORS

INTRODUCTION AND FEATURESThank you for selecting the Vector® Model VEC1087 A, 2/6/10 Amp 12 volt Smart Battery Charger. With proper care anduse, it wi

Page 6

VEC1087 AREV1011035CONTROLS AND INDICATORSThere are four (4) LED indicators and one button switch (select charge rate) that make up the controls and i

Page 7 - CARE AND MAINTENANCE

6FIGURE 3CHARGING IF BATTERY IS INSTALLED IN A VEHICLEa) Check polarity of battery posts - For top-mounted battery posts, the Positive post (marked PO

Page 8

VEC1087 AREV1011037CHARGING IF BATTERY IS OUTSIDE OF VEHICLEa) Check polarity of battery posts- For top-mounted battery posts, the positive post (mark

Page 9 - APPENDIXA - CHARGING TIMES

VEC1087 AREV1011038TROUBLESHOOTING – FAULT LED LITNOTE: Charger will NOT operate on batteries below 4.0 Volts. If a 12 Volt battery is below 4.0 Volts

Page 10 - VEC1087 A

VEC1087 AREV1011039APPENDIXA - CHARGING TIMESTo calculate the approximate charging time required to fully charge a battery, it is necessary to determ

Commentaires sur ces manuels

Pas de commentaire