Vector V08 Manuel d'utilisateur télécharger pdf (Page 29)

INSTALLATION DIRECTIVEMAY 2006

V08 ENT M75

M11

M12

Revolution-counter calibration

1. Adjustment screw - 2. Panel lighting lamp.

Verify the indication of the panel revolution counter by

comparing it with the one measured with a reference

instrument; if it differs, operate the adjustment screw (1),

located in the rear part of the revolution counter, until

consistency is achieved; repeat the operation for different

engine rpms.

Maintenance

Should it become necessary to replace a panel light, remove

the lamp holder from the rear part of the instrument (see

Figure 27A).

Figure 27A





04_255_N

Revolution-counter calibration

1. Calibration increasing button -

2.Calibration decreasing button.

Verify the indication of the panel revolution counter by com-

paring it with the one measured with a reference instrument;

if it differs, press the button 1 and 2 situated on the rear

of the tachometer, until consistency is achieved; repeat the

operation for different engine rpms.

Maintenance

The board is illuminated by not-replaceable internal LEDs.

Figure 27B





06_113_V

1 2

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 59 60

Pas de commentaire

Vector V08 Manuel d'utilisateur Page 29