Vector SIMOVERT MASTERDRIVES 6SE70 VC Instructions d'exploitation télécharger pdf (Page 146)

Maintenance Vector Control Chassis Type Frequency Converter

476 869 4070 76 J AB-74 Siemens AG

12-6 Operating Instructions SIMOVERT MASTERDRIVES

12.7 Replacing the SML and the SMU

SML: Snubber Module Lower

SMU: Snubber Module Upper

♦

Remove the capacitor battery.

♦

Undo the fixing screws (4 x M8, 8 - 10 Nm or 4 x M6, 2.5 - 5 Nm, 1 x

M4, max 1.8 Nm).

♦

Remove the modules.

Install the new modules in the reverse sequence.

12.8 Removing and installing the module busbars

(from type G)

♦

Remove the capacitor battery.

♦

Undo the screws of the module busbars.

M8 power connections

M6 fastening on spacers

M4 circuit.

♦

Take out the insulation of the SMU / SML.

♦

Lift out the module busbars.

The spacing between the plus busbar and the minus busbar must be at

least 4 mm. In order to install the module busbars, you must therefore

use a template, e.g. a 4 mm thick piece of plastic.

♦

Place the module busbars and SMU/SML insulation on spacer bolts

and fix in place (M6).

♦

Place the template instead of the DC link bus module in the module

busbars.

♦

Locate the SMU and SML and tighten the modular connections (M8,

8 - 10 Nm, M6, 2.5 - 5 Nm).

♦

Screw the nuts tight on the spacer bolts (6 Nm).

♦

Connect the circuit resistors (M4, 1.8 Nm).

♦

Tighten the power connections (M8, 13 Nm).

♦

Remove the template from the module busbars.

Module screw

connection

Module

screw con-

nection

−

Template 4 mm

Fig. 12-4 Installing the module busbars

Removal

Installation

NOTE

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 161 162

Commentaires sur ces manuels

Pas de commentaire

Vector SIMOVERT MASTERDRIVES 6SE70 VC Instructions d'exploitation Page 146

Commentaires sur ces manuels

Produits connexes et manuels pour Composants de châssis Vector SIMOVERT MASTERDRIVES 6SE70 VC