Vector SIMOVERT MASTERDRIVES 6SE70 VC Instructions d'exploitation télécharger pdf (Page 98)

Parameterizing steps Vector Control Chassis Type Frequency Converter

476 869 4070 76 J AB-74 Siemens AG

9-34 Operating Instructions SIMOVERT MASTERDRIVES

9.3.2 Board configuration

During board configuration, the control electronics is informed in what

way the installed optional boards have to be configured. This step is

always necessary if optional boards are used.

The unit must be switched to the "Board configuration" status for this

purpose. This is done by selecting the "Board configuration" menu. In

this menu, parameters are set which are required for adapting the

optional boards to the specific application (e.g. bus addresses, baud

rates, etc.). After leaving the menu, the set parameters are transferred

and the optional boards are initialized.

P060 = 4

Select "Board configuration" menu

SCB protocol

0: SCI

1: USS 4-wire

2: USS 2-wire

3: Peer-to-Peer

P696 = ?

SCB inserted ?

yes

Enter the CB parameters 1 to 11 necessary for the inserted

communications boards CBx

The necessary CB parameters and their significance can be

derived from the function diagrams of the individual

communications boards.

P711.1...2 = ?

P721.1...10 = ?

CBx inserted ?

yes

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 161 162

Pas de commentaire

Vector SIMOVERT MASTERDRIVES 6SE70 VC Instructions d'exploitation Page 98